When it comes to troubleshooting problems in a router, then the first thing that comes to the minds of many people is reboot the router. To do this, turn off the router, the power cord needs to be unplugged and then, the user must wait 10 seconds before plugging the cord back in.
If the problem continues after the reboot, you can proceed with the following workarounds:
Flashing or falling
There are many reasons why you may have a weak signal or connection. Here are several ways to solve it:
Cause 1: Your intermittent wireless connection is related to the type of setting you have in your home or office.
Solution: The location of your wireless device is the key to having a good signal from your router. The following is an article that can help you solve the fall of the wireless connection in different circumstances.
Place the router in an open and strategic area as this device uses radio waves to communicate.
In addition, it is not recommended to place the wireless device or computer attached to the router because the 45.7 cm radius around the router is a wireless dead zone.
Make sure that the distance between the router and the wireless device must be three (3) meters for better signal reception.
Cause 2: An intermittent connection may also have something to do with the Internet service provider (ISP) you are subscribed to.
Solution: To test for ISP connection problems, connect one computer directly to the modem using an Ethernet cable and observe the connection for a few hours. If you continue to have connection problems, this may be an ISP problem. Contact your ISP for technical support.
Cause 3: The security mode you have configured can also affect the speed and power of your wireless signal.
Solution: Ensure that the security mode is set to Personal WPA2. WEP reduces the speed of the network to G mode and set it to WPA2-AES or Open will allow you to have optimal wireless-N speed. You can check the wireless security mode your router uses on the web-based configuration page.
NOTE: Use the Open option only if you want to configure a public wireless network or implement the MAC filter. For maximum security and compatibility with most wireless devices, do not use special characters in WPA passwords. Use instead a combination of numbers and / or uppercase and lowercase letters.
Cause 4: The firmware on your router is outdated.
Solution: If the problem persists after performing the steps above, this may mean that you need to update the firmware. However, if you are using the latest version of the firmware, it is possible to perform a re-flash firmware. The re-flash process allows you to update the firmware for a version similar to the one you are currently using.
That sums up the discussion of most common problems in Linksys router setup along with their solutions. If you are dealing with a different kind of problem, then you can contact Linksys router experts for the best solution to it.
If you want to know in details about Linksys wireless router setup & how to setup Linksys wireless router then visit to the Linksys official website link https://www.linksys.com/us/c/wireless-routers/